Suchergebnisse

The last 40 years have seen major changes in the sources and concentrations of urban pollution (nitrogen dioxide, sulfur dioxide, hydrogen sulfide, and particulates). During this time, research has advanced our understanding of the impact of pollutants on objects in urban museums. As a consequence, pollutant control has become an important aspect of preventive conservation. There is also increased awareness of the need for pollution control strategies that are sustainable at an organizational and global level. This report, prepared by a chemist, a conservator, and two building scientists, reviews strategies for minimizing the impact of urban pollution on museum collections. The results of new research funded by the UK government identify current (1999) internal pollution levels in both naturally ventilated and air-conditioned museums with particle and gaseous filtration, in relation to external concentrations, ventilation strategies, and the characteristics of the internal fabric and finishes of these buildings. The last 40 years have seen major changes in the sources and concentrations of urban pollution (nitrogen dioxide, sulfur dioxide, hydrogen sulfide, and particulates). During this time, research has advanced our understanding of the impact of pollutants on objects in urban museums. As a consequence, pollutant control has become an important aspect of preventive conservation. There is also increased awareness of the need for pollution control strategies that are sustainable at an organizational and global level. This report, prepared by a chemist, a conservator, and two building scientists, reviews strategies for minimizing the impact of urban pollution on museum collections. The results of new research funded by the UK government identify current (1999) internal pollution levels in both naturally ventilated and air-conditioned museums with particle and gaseous filtration, in relation to external concentrations, ventilation strategies, and the characteristics of the internal fabric and finishes of these buildings.

This paper reports results from the monitoring part of a recent UK Department of Health funded project investigating carbon monoxide (CO) levels in homes during the winter of 2002/2003. In all, 56 homes were monitored for carbon monoxide in 3 cities across the UK. The homes were selected as part of the UK government Warm Front evaluation programme (aimed at reducing fuel poverty) and might be expected to have a higher incidence of problem gas appliances emitting higher than average amounts of CO than the general population. However the ventilation rate of these homes might also be expected to be higher. Measurements of CO were taken at 15-minute intervals in a representative location in the main living area of each home. Thirteen or 23% of the homes were found to exceed the WHO guideline values for ambient CO concentrations. In each home that exceeded the guidelines an assessment of source concentration of each appliance was made by an expert gas engineer, it was found that old, poor quality gas appliances caused a large proportion of exceedances seen.

Reducing space heating energy demand supports the UK's legislated carbon emission reduction targets and requires the effective characterisation of the UK's existing housing stock to facilitate retrofitting decision-making. Approximately 6.6 million UK dwellings pre-date 1919 and are predominantly of suspended timber ground floor construction, the thermal performance of which has not been extensively investigated. This paper examines suspended timber ground floor heat-flow by presenting high resolution in-situ heat-flux measurements undertaken in a case study house at 15 point locations on the floor. The results highlight significant variability in observed heat-flow: point U-values range from 0.56 ± 0.05 to 1.18 ± 0.11 Wm−2 K−1. This highlights that observing only a few measurements is unlikely to be representative of the whole floor heat-flow and the extrapolation from such point values to whole floor U-value estimates could lead to its over- or under- estimation. Floor U-value models appear to underestimate the actual measured floor U-value in this case study. This paper highlights the care with which in-situ heat-flux measuring must be undertaken to enable comparison with models, literature and between studies and the findings support the unique, high-resolution in-situ monitoring methodology used in this study for further research in this area.