Suchergebnisse

This article is available under the Creative Commons CC-BY-NC-ND license and permits non-commercial use of the work as published, without adaptation or alteration provided the work is fully attributed. For commercial reuse, permission must be requested below. ; The Optical, Spectroscopic, and Infrared Remote Imaging System (OSIRIS) onboard the European Space Agency's Rosetta spacecraft acquired images of comet 67P/Churyumov–Gerasimenko (67P) and its surrounding dust coma starting from May 2014 until September 2016. In this paper we present methods and results from analysis of OSIRIS images regarding the dust outflow in the innermost coma of 67P. The aim is to determine the global dust outflow behaviour and place constraints on physical processes affecting particles in the inner coma. We study the coma region right above the nucleus surface, spanning from the nucleus centre out to a distance of about 50 km comet centric distance (approximately 25 average comet radii). We primarily adopt an approach used by Thomas and Keller (1990) to study the dust outflow. We present the effects on azimuthally-averaged values of the dust reflectance of non-radial flow and non-point-source geometry, acceleration of dust particles, sublimation of icy dust particles after ejection from the surface, dust particle fragmentation, optical depth effects and the influence of gravitationally bound particles. All of these physical processes could modify the observed distribution of light scattered by the dust coma. In the image analysis, profiles of azimuthally averaged dust brightness as a function of impact parameter b (azimuthal average, "Ā-curve") were fitted with a simple function that best fits the shape of our profile curves (f(b;u,v,w,z)=u/b+wb+z). The analytical fit parameters (u, v, w, z), which hold the key information about the dust outflow behaviour, were saved in a comprehensive database. Through statistical analysis of these information, we show that the spatial distribution of dust follows free-radial outflow behaviour (i.e. force-free radial outflow with constant velocity) beyond distances larger than ∼11.9 km from the comet centre, which corresponds to a relative distance of about 6 average comet radii from the comet centre. Hence, we conclude that beyond this distance, and on average, fragmentation and gravitationally bound particles are negligible processes in determining the optically scattered light distribution in the innermost coma. Closer to the nucleus we observe dust outflow behaviour that deviates from free-radial outflow. A comparison of our result profiles with numerical models using a Direct Simulation Monte Carlo (DSMC) approach with dust particle distributions calculated using a test particle approach has been used to demonstrate the influence of a complex shape and particle acceleration on the azimuthal average profiles. We demonstrate that, while other effects such as fragmentation or sublimation of dust particles cannot be ruled out, acceleration of the dust particles and effects arising from the shape of the irregular nucleus (non-point source geometry) are sufficient to explain the observed dust outflow behaviour from image data analysis. As a by-product of this work, we have calculated "Afρ" values for the 1/r regime. We found a peak in the coma activity in terms of Afρ (normalised to a phase angle of 90°) of ∼210 cm 20 days after perihelion. Furthermore, based on simplified models of particle motion within bound orbits, it is shown that limits on the total cross-sectional area of bound particles might be derived through further analysis. An example is given. © 2018 The Authors ; The team from the University of Bern is supported through the Swiss National Science Foundation and through the NCCR PlanetS. The project has also received funding from the European Union's Horizon 2020 research and innovation programme under grant agreement No. 686709. This work was supported by the Swiss State Secretariat for Education, Research and Innovation (SERI) under contract number 16.0008-2. The opinions expressed and arguments employed herein do not necessarily reflect the official views of the Swiss Government.

Open Access article, published by EDP Sciences, under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. ; We directly measured twenty overhanging cliffs on the surface of comet 67P/Churyumov-Gerasimenko extracted from the latest shape model and estimated the minimum tensile strengths needed to support them against collapse under the comet's gravity. We find extremely low strengths of around 1 Pa or less (1 to 5 Pa, when scaled to a metre length). The presence of eroded material at the base of most overhangs, as well as the observed collapse of two features and the implied previous collapse of another, suggests that they are prone to failure and that the true material strengths are close to these lower limits (although we only consider static stresses and not dynamic stress from, for example, cometary activity). Thus, a tensile strength of a few pascals is a good approximation for the tensile strength of the 67P nucleus material, which is in agreement with previous work. We find no particular trends in overhang properties either with size over the ~10-100 m range studied here or location on the nucleus. There are no obvious differences, in terms of strength, height or evidence of collapse, between the populations of overhangs on the two cometary lobes, suggesting that 67P is relatively homogenous in terms of tensile strength. Low material strengths are supportive of cometary formation as a primordial rubble pile or by collisional fragmentation of a small body (tens of km). ; his project has received funding from the European Union's Horizon 2020 research and innovation programme under grant agreement no. 686709. This work was supported by the Swiss State Secretariat for Education, Research and Innovation (SERI) under contract number 16.0008-2. The opinions expressed and arguments employed herein do not necessarily reflect the official view of the Swiss Government. OSIRIS was built by a consortium of the Max-Planck-Institut fur Sonnensystemforschung, Gottingen, Germany; the CISAS University of Padova, Italy; the Laboratoire d'Astrophysique de Marseille, France; the Instituto de Astrofisica de Andalucia, CSIC, Granada, the Universidad Politechnica de Madrid, Spain; the Department of Physics and Astronomy of Uppsala University, Sweden; and the Institut fur Datentechnik und Kommunikationsnetze der Technischen Universitat Braunschweig, Germany. The support of the national funding agencies of Germany (DLR), France (CNES), Italy (ASI), Spain (MEC), Sweden (SNSB), and the ESA Technical Directorate is gratefully acknowledged. We thank the Rosetta Science Operations Centre and the Rosetta Mission Operations Centre for the successful rendezvous with comet 67P/Churyumov-Gerasimenko.

Haumea—one of the four known trans-Neptunian dwarf planets—is a very elongated and rapidly rotating body1, 2, 3. In contrast to other dwarf planets4, 5, 6, its size, shape, albedo and density are not well constrained. The Centaur Chariklo was the first body other than a giant planet known to have a ring system7, and the Centaur Chiron was later found to possess something similar to Chariklo's rings8, 9. Here we report observations from multiple Earth-based observatories of Haumea passing in front of a distant star (a multi-chord stellar occultation). Secondary events observed around the main body of Haumea are consistent with the presence of a ring with an opacity of 0.5, width of 70 kilometres and radius of about 2,287 kilometres. The ring is coplanar with both Haumea's equator and the orbit of its satellite Hi'iaka. The radius of the ring places it close to the 3:1 mean-motion resonance with Haumea's spin period—that is, Haumea rotates three times on its axis in the time that a ring particle completes one revolution. The occultation by the main body provides an instantaneous elliptical projected shape with axes of about 1,704 kilometres and 1,138 kilometres. Combined with rotational light curves, the occultation constrains the three-dimensional orientation of Haumea and its triaxial shape, which is inconsistent with a homogeneous body in hydrostatic equilibrium. Haumea's largest axis is at least 2,322 kilometres, larger than previously thought, implying an upper limit for its density of 1,885 kilograms per cubic metre and a geometric albedo of 0.51, both smaller than previous estimates1, 10, 11. In addition, this estimate of the density of Haumea is closer to that of Pluto than are previous estimates, in line with expectations. No global nitrogen- or methane-dominated atmosphere was detected. ; J.L.O. acknowledges funding from Spanish and Andalusian grants MINECO AYA-2014-56637-C2-1-P and J. A. 2012-FQM1776 as well as FEDER funds. Part of the research leading to these results received funding from the European Union's Horizon 2020 Research and Innovation Programme, under grant agreement no. 687378. B.S. acknowledges support from the French grants 'Beyond Neptune' ANR-08-BLAN-0177 and 'Beyond Neptune II' ANR-11-IS56-0002. Part of the research leading to these results has received funding from the European Research Council under the European Community's H2020 (2014-2020/ERC grant agreement no. 669416 'Lucky Star'). A.P. and R.S. have been supported by the grant LP2012-31 of the Hungarian Academy of Sciences. All of the Hungarian contributors acknowledge the partial support from K-125015 grant of the National Research, Development and Innovation Office (NKFIH). G.B.-R., F.B.-R., F.L.R., R.V.-M., J.I.B.C., M.A., A.R.G.-J. and B.E.M. acknowledge support from CAPES, CNPq and FAPERJ. J.C.G. acknowledges funding from AYA2015-63939-C2-2-P and from the Generalitat Valenciana PROMETEOII/2014/057. K.H. and P.P. were supported by the project RVO:67985815. The Astronomical Observatory of the Autonomous Region of the Aosta Valley acknowledges a Shoemaker NEO Grant 2013 from The Planetary Society. We acknowledge funds from a 2016 'Research and Education' grant from Fondazione CRT. We also acknowledge the Slovakian project ITMS no. 26220120029.