Suchergebnisse

Pharmaceuticals, such as non-steroidal anti-inflammatory drugs (NSAIDs) and their metabolites, have become a major concern due to their increasing consumption and their widespread occurrence in the environment. In this paper, we investigate the occurrence of NSAIDs and their metabolites in an urban aquifer, which may serve as a potential resource for drinking water, and propose a methodology to assess the removal of these substances in the river–groundwater interface. Then, risk quotients (RQs) are computed, in order to determine the risk posed by the single NSAIDs and their mixture to human health. To this end, six NSAIDs and two metabolites were collected from an urban aquifer located in the metropolitan area of Barcelona (NE, Spain), in which the major pollution source is a contaminated river. All of the target NSAIDs were detected in groundwater samples, where the concentrations in the aquifer were higher than those found in the river water (except for ibuprofen). Diclofenac, ketoprofen, propyphenazone and salicylic acid were detected at high mean concentrations (ranging from 91.8 ng/L to 225.2 ng/L) in the aquifer. In contrast, phenazone and mefenamic acid were found at low mean concentrations (i.e., lower than 25 ng/L) in the aquifer. According to the proposed approach, the mixing of river water recharge into the aquifer seemed to some extent to promote the removal of the NSAIDs under the sub-oxic to denitrifying conditions found in the groundwater. The NSAIDs that presented higher mean removal values were 4OH diclofenac (0.8), ibuprofen (0.78), salicylic acid (0.35) and diclofenac (0.28), which are likely to be naturally attenuated under the aforementioned redox conditions. Concerning human health risk assessment, the NSAIDs detected in groundwater and their mixture do not pose any risk for all age intervals considered, as the associated RQs were all less than 0.05. Nevertheless, this value must be taken with caution, as many pharmaceuticals might occur simultaneously in the groundwater. ; IDAEA-CSIC is a Centre of Excellence Severo Ochoa (Spanish Ministry of Science and Innovation, Project CEX2018-000794-S). A. J gratefully acknowledges the support from the Secretary for Universities and Research of the Ministry of Economy and Knowledge of the Government of Catalonia and the Marie Sklodowska-Curie COFUND of the programme H2020 (BP3, contract number 801370). The authors would like to thank the European Commission, the Spanish Foundation for Science & Technology (FECYT) and State Research Agency (AEI)) for funding in the frame of the collaborative international consortium (URBANWAT) financed under the 2018 Joint call of the WaterWorks2017 ERA-NET Cofund. This ERA-NET is an integral part of the activities developed by the Water JPI. Additionally, authors would also thank the Ministry of Science, Innovation and Universities, for funding the projects UNBIASED (Ref: RTI2018-097346-B-I00) under the 2018 call of the "Proyectos de I+D Retos Investigación" and INTEGRATE (Ref: PID2019-107945RJ-I00) under the 2019 call of the "Proyectos de I+D Retos Investigación". ; Peer reviewed

Deep geothermal energy (DGE) represents an opportunity for a sustainable and carbon-free energy supply. One of the main concerns of DGE is induced seismicity that may produce damaging earthquakes, challenging its widespread exploitation. It is widely believed that the seismicity risk can be controlled by using doublet systems circulating water to minimize the injection-induced pressure changes. However, cold water reinjection may also give rise to thermal stresses within and beyond the cooled region, whose potential impacts on fault reactivation are less well understood. Here, we investigate by coupled thermo-hydro-mechanical modeling the processes that may lead to fault reactivation in a hot sedimentary aquifer (HSA) in which water is circulated through a doublet. We show that thermal stresses are transmitted much ahead of the cooled region and are likely to destabilize faults located far away from the doublet. Meanwhile, the fault permeability mainly controls the fault reactivation timing, which entails the importance of employing appropriate characterization methods. This investigation is crucial for understanding the mechanisms controlling induced seismicity associated with DGE in a HSA and allows the success of future DGE projects. ; I.R.K. and V.V. acknowledge funding from the European Research Council (ERC) under the ‎European Union's Horizon 2020 Research and Innovation Program through the Starting Grant ‎GEoREST (http://www.georest.eu) under Grant agreement No. 801809. I.R.K. also acknowledges support by the grant IJC2020-043809-I funded by MCIN/AEI/ 10.13039/501100011033 and the European Union NextGenerationEU/PRTR. IDAEA-CSIC is a Centre of Excellence Severo Ochoa (Spanish ‎Ministry of Science and Innovation, Grant CEX2018-000794-S funded by MCIN/AEI/ 10.13039/501100011033). Additional funding was provided to J.R. by the U.S. Department of Energy under contract No. DE-AC0205CH11231 to the Lawrence Berkeley National Laboratory and to E.P. through the grant RYC2020-029225-I funded by MCIN/AEI/ 10.13039/501100011033. ; Peer reviewed

AbstractWater provision and distribution are subject to conflicts between users worldwide, with agriculture as a major driver of discords. Water sensitive ecosystems and their services are often impaired by man-made water shortage. Nevertheless, they are not sufficiently included in sustainability or risk assessments and neglected when it comes to distribution of available water resources. The herein presented contribution to the Sustainable Development Goals Clean Water and Sanitation (SDG 6) and Life on Land (SDG 15) is the Ecological Sustainability Assessment of Water distribution (ESAW-tool). The ESAW-tool introduces a watershed sustainability assessment that evaluates the sustainability of the water supply-demand ratio on basin level, where domestic water use and the water requirements of ecosystems are considered as most important water users. An ecological risk assessment estimates potential impacts of agricultural depletion of renewable water resources on (ground)water-dependent ecosystems. The ESAW-tool works in standard GIS applications and is applicable in basins worldwide with a set of broadly available input data. The ESAW-tool is tested in the Danube river basin through combination of high-resolution hydro-agroecological model data (hydrological land surface process model PROMET and groundwater model OpenGeoSys) and further freely available data (water use, biodiversity and wetlands maps). Based on the results, measures for more sustainable water management can be deduced, such as increase of rainfed agriculture near vulnerable ecosystems or change of certain crops. The tool can support decision making of authorities from local to national level as well as private enterprises who want to improve the sustainability of their supply chains.

AkvaGIS is a novel, free and open source module included in the FREEWAT plugin for QGIS that supplies a standardized and easy-to-use workflow for the storage, management, visualization and analysis of hydrochemical and hydrogeological data. The main application is devised to simplify the characterization of groundwater bodies for the purpose of building rigorous and data-based environmental conceptual models (as required in Europe by the Water Framework Directive). For data-based groundwater management, AkvaGIS can be used to prepare input files for most groundwater flow numerical models in all of the available formats in QGIS. AkvaGIS is applied in the Walloon Region (Belgium) to demonstrate its functionalities. The results support a better understanding of the hydrochemical relationship among aquifers in the region and can be used as a baseline for the development of new analyses, e.g., further delineation of nitrate vulnerable zones and management of the monitoring network to control chemical spatial and temporal evolution. AkvaGIS can be expanded and adapted for further environmental applications as the FREEWAT community grows. © 2018 The Authors ; Funding text This paper is presented within the framework of the project FREEWAT , which received funding from the European Union's Horizon 2020 research and innovation programme under Grant Agreement n. 642224 . R. Criollo thanks the financial support from the Catalan Industrial Doctorates Plan of the Secretariat for Universities and Research , Ministry of Economy and Knowledge of the Generalitat de Catalunya . A. Jurado and E. Pujades gratefully acknowledge the financial support from the University of Liège and the EU through the Marie Curie BeIPD-COFUND postdoctoral fellowship programme (2015–2017 and 2014–2016 fellows from FP7-MSCA-COFUND , 600405 ). ; Peer reviewed