Suchergebnisse

Phase IV of BEMUSE Program is a necessary step for a subsequent uncertainty analysis. It includes the simulation of the reference scenario and a sensitivity study. The scenario is a LBLOCA and the reference plant is Zion 1 NPP, a 4 loop PWR unit. Thirteen participants coming from ten different countries have taken part in the exercise. The BEMUSE (Best Estimate Methods plus Uncertainty and Sensitivity Evaluation) Program has been promoted by the Working Group on Accident Management and Analysis (WGAMA) and endorsed by the Committee on the Safety of Nuclear Installations (CSNI). The paper presents the results of the calculations performed by participants and emphasizes its usefulness for future uncertainty evaluation, to be performed in next phase. The objectives of the activity are basically to simulate the LBLOCA reproducing the phenomena associated to the scenario and also to build a common, well-known, basis for the future comparison of uncertainty evaluation results among different methodologies and codes. The sensitivity calculations performed by participants are also presented. They allow studying the influence of different parameters such as material properties or initial and boundary conditions, upon the behaviour of the most relevant parameters related to the scenario.

This article is available under the Creative Commons CC-BY-NC-ND license and permits non-commercial use of the work as published, without adaptation or alteration provided the work is fully attributed. For commercial reuse, permission must be requested below. ; The Optical, Spectroscopic, and Infrared Remote Imaging System (OSIRIS) onboard the European Space Agency's Rosetta spacecraft acquired images of comet 67P/Churyumov–Gerasimenko (67P) and its surrounding dust coma starting from May 2014 until September 2016. In this paper we present methods and results from analysis of OSIRIS images regarding the dust outflow in the innermost coma of 67P. The aim is to determine the global dust outflow behaviour and place constraints on physical processes affecting particles in the inner coma. We study the coma region right above the nucleus surface, spanning from the nucleus centre out to a distance of about 50 km comet centric distance (approximately 25 average comet radii). We primarily adopt an approach used by Thomas and Keller (1990) to study the dust outflow. We present the effects on azimuthally-averaged values of the dust reflectance of non-radial flow and non-point-source geometry, acceleration of dust particles, sublimation of icy dust particles after ejection from the surface, dust particle fragmentation, optical depth effects and the influence of gravitationally bound particles. All of these physical processes could modify the observed distribution of light scattered by the dust coma. In the image analysis, profiles of azimuthally averaged dust brightness as a function of impact parameter b (azimuthal average, "Ā-curve") were fitted with a simple function that best fits the shape of our profile curves (f(b;u,v,w,z)=u/b+wb+z). The analytical fit parameters (u, v, w, z), which hold the key information about the dust outflow behaviour, were saved in a comprehensive database. Through statistical analysis of these information, we show that the spatial distribution of dust follows free-radial outflow behaviour (i.e. force-free radial outflow with constant velocity) beyond distances larger than ∼11.9 km from the comet centre, which corresponds to a relative distance of about 6 average comet radii from the comet centre. Hence, we conclude that beyond this distance, and on average, fragmentation and gravitationally bound particles are negligible processes in determining the optically scattered light distribution in the innermost coma. Closer to the nucleus we observe dust outflow behaviour that deviates from free-radial outflow. A comparison of our result profiles with numerical models using a Direct Simulation Monte Carlo (DSMC) approach with dust particle distributions calculated using a test particle approach has been used to demonstrate the influence of a complex shape and particle acceleration on the azimuthal average profiles. We demonstrate that, while other effects such as fragmentation or sublimation of dust particles cannot be ruled out, acceleration of the dust particles and effects arising from the shape of the irregular nucleus (non-point source geometry) are sufficient to explain the observed dust outflow behaviour from image data analysis. As a by-product of this work, we have calculated "Afρ" values for the 1/r regime. We found a peak in the coma activity in terms of Afρ (normalised to a phase angle of 90°) of ∼210 cm 20 days after perihelion. Furthermore, based on simplified models of particle motion within bound orbits, it is shown that limits on the total cross-sectional area of bound particles might be derived through further analysis. An example is given. © 2018 The Authors ; The team from the University of Bern is supported through the Swiss National Science Foundation and through the NCCR PlanetS. The project has also received funding from the European Union's Horizon 2020 research and innovation programme under grant agreement No. 686709. This work was supported by the Swiss State Secretariat for Education, Research and Innovation (SERI) under contract number 16.0008-2. The opinions expressed and arguments employed herein do not necessarily reflect the official views of the Swiss Government.