Suchergebnisse

We report the high-pressure synthesis and the equation of state (EOS) of a novel nickel carbide (Ni3C). It was synthesized in a diamond anvil cell at 184(5) GPa through a direct reaction of a nickel powder with carbon from the diamond anvils upon heating at 3500 (200) K. Ni3C has the cementite-type structure (Pnma space group, a = 4.519(2) angstrom, b = 5.801(2) angstrom, c = 4.009(3) angstrom), which was solved and refined based on in-situ synchrotron single-crystal X-ray diffraction. The pressure-volume data of Ni3C was obtained on decompression at room temperature and fitted to the 3rd order Burch-Murnaghan equation of state with the following parameters: V-0 = 147.7(8) angstrom(3), K-0 = 157(10) GPa, and K-0 = 7.8(6). Our results contribute to the understanding of the phase composition and properties of Earths outer core. ; Funding Agencies|Federal Ministry of Education and Research, Germany (BMBF)Federal Ministry of Education & Research (BMBF) [05K19WC1]; Deutsche Forschungsgemeinschaft (DFG)German Research Foundation (DFG) [DU 954-11/1, DU 393-9/2, DU 393-13/1]; Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linkoping University (Faculty Grant SFO-Mat-LiU) [2009 00971]

The high-pressure synthesis of rhenium nitride pernitride with a crystal structure that is unusual for transition metal dinitrides and high values of hardness and bulk modulus attracted significant attention to this system. We investigate the thermodynamic and electronic properties of the P2(1)/c phase of ReN2 and compare them with two other polytypes, the C2/m and P4/mbm phases, suggested in the literature. Our calculations of the formation enthalpy at zero temperature show that the former phase is the most stable of the three up to a pressure p = 170 GPa, followed by the stabilization of the P4/mbm phase at higher pressure. The theoretical prediction is confirmed by diamond anvil cell synthesis of the P4/mbm ReN2 at approximate to 175 GPa. Considering the effects of finite temperature in the quasiharmonic approximation at p = 100 GPa we demonstrate that the P2(1)/c phase has the lowest free energy of formation at least up to 1000 K. Our analysis of the pressure dependence of the electronic structure of rhenium nitride pernitride shows the presence of two electronic topological transitions around 18 GPa, when the Fermi surface changes its topology due to the appearance of an electron pocket at the high-symmetry Y-2 point of the Brillouin zone while the disruption of the neck takes place slightly off from the Gamma-A line. ; Funding Agencies|Knut and Alice Wallenberg Foundation (Wallenberg Scholar Grant) [KAW-2018.0194]; Swedish Government Strategic Research Areas in Materials Science on Functional Materials at Linkoping University (Faculty Grant SFO-Mat-LiU) [2009 00971]; SeRC, the Swedish Research Council (VR) [2019-05600]; VINN Excellence Center Functional Nanoscale Materials (FunMat-2) [201605156]; Russian Science FoundationRussian Science Foundation (RSF) [18-12-00492]; Swedish Research CouncilSwedish Research CouncilEuropean Commission [2016-07213]

The experimental study of hydrogen-bonds and their symmetrization under extreme conditions is predominantly driven by diffraction methods, despite challenges of localising or probing the hydrogen subsystems directly. Until recently, H-bond symmetrization has been addressed in terms of either nuclear quantum effects, spin crossovers or direct structural transitions; often leading to contradictory interpretations when combined. Here, we present high-resolution in-situ 1H-NMR experiments in diamond anvil cells investigating a range of systems containing linear O-H ⋯ O units at pressure ranges of up to 90 GPa covering their respective H-bond symmetrization. We found pronounced minima in the pressure dependence of the NMR resonance line-widths associated with a maximum in hydrogen mobility, precursor to a localisation of hydrogen atoms. These minima, independent of the chemical environment of the O-H ⋯ O unit, can be found in a narrow range of oxygen oxygen distances between 2.44 and 2.45 Å, leading to an average critical oxygen-oxygen distance of Å. ; Funding: German Research Foundation (Deutsche Forschungsgemeinschaft, DFG) [DU 393/13-1, DU 393/9-2, STE 1105/13-1, ME 5206/3-1, DU 954/111]; Federal Ministry of Education and Research, Germany (BMBF) [05K19WC1]; Center for High Pressure Science and Technology Advance Research, Beijing, P.R. China; Swedish Research Council (VR) [2019-05600]; Alexander von Humboldt Foundation; Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linkoping University (Faculty Grant SFO-Mat-LiU) [2009 00971]

Recent developments in in situ nuclear magnetic resonance (NMR) spectroscopy under extreme conditions have led to the observation of a wide variety of physical phenomena that are not accessible with standard high-pressure experimental probes. However, inherent di- or quadrupolar line broadening in diamond anvil cell (DAC)-based NMR experiments often limits detailed investigation of local atomic structures, especially if different phases or local environments coexist. Here, we describe our progress in the development of high-resolution NMR experiments in DACs using one- and two-dimensional homonuclear decoupling experiments at pressures up to the megabar regime. Using this technique, spectral resolutions of the order of 1 ppm and below have been achieved, enabling high-pressure structural analysis. Several examples are presented that demonstrate the wide applicability of this method for extreme conditions research. ; Funding: German Research Foundation (Deutsche Forschungsgemeinschaft, DFG)German Research Foundation (DFG) [DU 954/11-1, DU 393/13-1, DU 393/9-2]; Federal Ministry of Education and Research, Germany (BMBF)Federal Ministry of Education & Research (BMBF) [05K19WC1]; Center for High Pressure Science and Technology Advanced Research; Swedish Research Council (VR)Swedish Research Council [2019-05600]; Alexander von Humboldt FoundationAlexander von Humboldt Foundation; Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linkoping University [2009 00971]; [ME 5206/3-1]

Laser heating of rhenium in a diamond anvil cell to 3000 +/- 300 K at about 200 GPa results in formation of two previously unknown rhenium carbides, hexagonal WC-type structured ReC and orthorhombic TiSi2-type structured ReC2. The shortest C-C distances [1.758(3) angstrom at 219(5) GPa and 1.850(4) angstrom at 180(7) GPa] found in honeycomb-like carbon nets in the structure of ReC2 are quite unusual. The Re-C solid solution formed at multimegabar pressure has the carbon content of approximate to 20 at%. ; Funding Agencies|Federal Ministry of Education and Research, Germany (BMBF)Federal Ministry of Education & Research (BMBF) [5K16WC1, 05K19WC1]; Deutsche Forschungsgemeinschaft (DFG)German Research Foundation (DFG) [DU 954-11/1, DU 393-9/2, DU 393-13/1]; Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linkoping University (Faculty Grant SFO-Mat-LiU) [2009 00971]

It is widely accepted that the lower mantle consists of mainly three major minerals-ferropericlase, bridgmanite and calcium silicate perovskite. Ferropericlase ((Mg,Fe)O) is the second most abundant of the three, comprising approximately 16-20 wt% of the lower mantle. The stability of ferropericlase at conditions of the lowermost mantle has been highly investigated, with controversial results. Amongst other reasons, the experimental conditions during laser heating (such as duration and achieved temperature) have been suggested as a possible explanation for the discrepancy. In this study, we investigate the effect of pulsed laser heating on the stability of ferropericlase, with a geochemically relevant composition of Mg0.76Fe0.24O (Fp24) at pressure conditions corresponding to the upper part of the lower mantle and at a wide temperature range. We report on the decomposition of Fp24 with the formation of a high-pressure (Mg,Fe)(3)O(4)phase with CaTi2O4-type structure, as well as the dissociation of Fp24 into Fe-rich and Mg-rich phases induced by pulsed laser heating. Our results provide further arguments that the chemical composition of the lower mantle is more complex than initially thought, and that the compositional inhomogeneity is not only a characteristic of the lowermost part, but includes depths as shallow as below the transition zone. ; Funding Agencies|Federal Ministry of Education and Research, Germany (BMBF)Federal Ministry of Education & Research (BMBF) [5K16WC1, 05K19WC1]; Deutsche Forschungsgemeinschaft (DFG)German Research Foundation (DFG) [DU 954-11/1, DU 393-9/2, DU 393-13/1]; Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linkoping University faculty grant SFO-Mat-LiU [2009 00971]

Polynitrides are intrinsically thermodynamically unstable at ambient conditions and require peculiar synthetic approaches. Now, a one-step synthesis of metal-inorganic frameworks Hf4N20 center dot N2, WN 8 center dot N2, and Os5N28 center dot 3N2 via direct reactions between elements in a diamond anvil cell at pressures exceeding 100 GPa is reported. The porous frameworks (Hf4N20, WN 8, and Os5N28) are built from transition-metal atoms linked either by polymeric polydiazenediyl (polyacetylene-like) nitrogen chains or through dinitrogen units. Triply bound dinitrogen molecules occupy channels of these frameworks. Owing to conjugated polydiazenediyl chains, these compounds exhibit metallic properties. The high-pressure reaction between Hf and N2 also leads to a non-centrosymmetric polynitride Hf2N11 that features double-helix catenapoly[tetraz-1-ene-1,4-diyl] nitrogen chains [-N-N-N=N-](infinity.) ; Funding Agencies|National Science Foundation-Earth SciencesNational Science Foundation (NSF) [EAR-1634415]; Department of Energy-GeoSciencesUnited States Department of Energy (DOE) [DE-FG02-94ER14466]; Army Research Office; Deutsche Forschungsgemeinschaft (DFG)German Research Foundation (DFG) [DU 95411/1, DU 393-9/2, DU 393-13/1]; Federal Ministry of Education and Research, Germany (BMBF)Federal Ministry of Education & Research (BMBF) [05K19WC1]; Russian Science FoundationRussian Science Foundation (RSF) [18-12-00492]; Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linkcping University (Faculty Grant SFO-Mat-LiU) [2009 00971]; Knut and AliceWallenberg FoundationKnut & Alice Wallenberg Foundation [KAW-2018.0194]; Swedish Research Council (VR)Swedish Research Council [2019-05600]; VINN Excellence Center Functional Nanoscale Materials (FunMat-2) [2016-05156]; [W911NF-19-2-0172]

Theoretical modelling predicts very unusual structures and properties of materials at extreme pressure and temperature conditions(1,2). Hitherto, their synthesis and investigation above 200 gigapascals have been hindered both by the technical complexity of ultrahigh-pressure experiments and by the absence of relevant in situ methods of materials analysis. Here we report on a methodology developed to enable experiments at static compression in the terapascal regime with laser heating. We apply this method to realize pressures of about 600 and 900 gigapascals in a laser-heated double-stage diamond anvil cell(3), producing a rhenium-nitrogen alloy and achieving the synthesis of rhenium nitride Re7N3-which, as our theoretical analysis shows, is only stable under extreme compression. Full chemical and structural characterization of the materials, realized using synchrotron single-crystal X-ray diffraction on microcrystals in situ, demonstrates the capabilities of the methodology to extend high-pressure crystallography to the terapascal regime. ; Funding Agencies: Alexander von Humboldt Foundation; Deutsche Forschungsgemeinschaft (DFG) [LA-4916/1-1, BY112/2-1, DU 954-11/1, DU 393-9/2, DU 393-13/2]; Federal Ministry of Education and Research, Germany (BMBF) [05K19WC1]; Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linköping University (Faculty Grant SFO-Mat-LiU) [200900971]; National Science Foundation -Earth Sciences [EAR -1634415]; DOE Office of Science [DE-AC02-06CH11357]; Russian Science Foundation [18-12-00492]; Knut and Alice Wallenberg Foundation (Wallenberg Scholar grant) [KAW-2018.0194]; Swedish Government Strategic Research Areas in Materials Science on Functional Materials at Linkoping University (Faculty Grant SFO-Mat-LiU) [2009 00971]; Swedish e-science Research Center (SeRC); Swedish Research Council (VR) [2019-05600]; Swedish Foundation for Strategic Research (SSF) [EM160004]; Swedish Research Council [2016-07213]; VINN Excellence Center Functional Nanoscale ...